Cl-3100 Monitoring System

FEATURES

Particles are sized greater than 0.5µm and 5µm. The standard flow rate is 1.0 cubic feet per minute, which limits the allowable concentration of particles to 1 million per cubic foot or 35.3 million per cubic meter. The sample volume can be collected in cubic foot mode (CF) or in cubic meter mode (CM). The sample time for the CF mode is 1 minute while the sample time for the CM mode is 35.3 minutes.

It is fully powered by a universal input power supply that will accept AC voltage from 100 to 240 VAC, 50/60 Hz. Two connections are made to the unit at its rear panel: a power cord (supplied with the unit), and a CAT 5 cable.

External Exhaust

The CI-3100 has a filtered external exhaust from the unit. The exhaust port on the rear panel of the unit is connected to an internal filter that collects the sampled particles and any particles generated by the sampling system.
There is an optional external exhaust tube fitting that can be installed so that the exhaust from the unit can be ported away from the unit or into an air return system. The tubing adapter is installed by unscrewing the exhaust hood from the rear panel and screwing in the tube fitting in its place.

Visual Indicators (Front)

The CI-3100 provides five LED indicators on the front of the unit: Power, Alarm, Count, Laser Status and Flow Status. The POWER LED (green) illuminates when the power is turned on. The ALARM LED (red) illuminates if the flow or laser LED is off for 2 consecutive seconds, and will remain on until both the laser and flow measurements are back within their nominal range. The COUNT LED (yellow) flashes with every occurrence of a particle, up to ten counts per second.
Higher concentrations will not flash any faster. The FLOW STATUS (green) LED is illuminated when there is flow through the sensor, measured with a mass flow sensor, and the flow rate is within ±10% of nominal. The LASER STATUS (green) LED is illuminated when the power level of the laser diode is within the factory set level ±10%. Both the flow and laser values are monitored 4 times per second, so their LEDs indicate in real time the flow and laser status.

Visual Indicators (Back)

The CI-3100 provides two small LED indicators on the rear of the unit. These indicators are on the Ethernet communications module. A green LED will be on solid when the unit has just been turned on or when the Ethernet module is rebooting. The green LED will be flashing when there is network traffic in and out of the sensor. An amber/orange LED will be on when the Ethernet module senses a connection to an external network.

Ethernet MODBUS connects to data acquisition platform

EU GMP Annex 1, ISO 144644-1, FS-209E calculation and printed Pass/Fail report
Meets or exceeds ISO 21501-4
Successfully brings ease of use and configurability to continuous monitoring
Dramatically simplifies operations, including setup, installation, connection, communication, and validation
Easy integration to your network system with many available communication options
Readily connects to a variety of data acquisition or standard monitoring platforms
Choice of internal built-in vacuum pump or external user-supplied vacuum source
Built-in flow rate sensor available for fail-safe operation
Laser status and flow measurement continuously monitored and controlled
Designed to minimize particle emission (certified ISO class 2 level emission)
Can be remotely controlled and monitored
Easy to clean rugged seamless stainless steel enclosure and small footprint